NTSB Factual Report

The pilot stated he was conducting a personal flight with the owner of the airplane. The owner did not have any flight time in make and model. The airplane had a pre-buy inspection conducted two days before the accident and no anomalies were noted. The pilot conducted a preflight inspection before the flight and no anomalies were noted. The pilot and the owner departed on runway 36 and remained in a left closed traffic pattern. The pilot made a three-point landing in the first 1,000 feet of the runway, and was on landing roll out, when the tail wheel started to shimmy. He applied forward pressure on the control stick and raised the tail wheel off the runway. The shimmy ceased and the pilot applied aft pressure on the control stick and lowered the tail wheel onto the runway. The airplane immediately veered to the right. The pilot applied left brake and rudder, but the airplane continued to the right off the right side of the runway and collided with a ditch. The right main landing gear separated and the right wing received structural damage. Examination of the airplane revealed the right spring on the tail wheel control had separated from the rudder and the tail wheel attachment. The tail wheel spring was located about 20 feet off the right side of the runway and there was no visible damage to the tail wheel spring or the upper and lower attachments points. The previous owner stated that he informed the new owner of the tendency for the tail wheel to shimmy during three-point landings.

NTSB Probable Cause

The separation of the right tail wheel spring on landing roll out for undetermined reasons, resulting in a loss of directional control and collision with a ditch.