NTSB Factual Report

HISTORY OF FLIGHT

On December 28, 2011, about 0951 eastern standard time, a Cessna 650, N877G, was substantially damaged when it impacted an airport perimeter fence while returning for landing at Fort Lauderdale Executive Airport (FXE), Fort Lauderdale, Florida. The two crewmembers and six passengers were not injured. The airplane had just taken off from FXE in visual meteorological conditions on an instrument flight rules flight plan to Teterboro Airport (TEB), Teterboro, New Jersey. The personal flight was operating under the provisions of 14 Code of Federal Regulations Part 91.

According to the first officer, the takeoff roll and rotation from runway 26 were "normal," but once airborne, the airplane began rolling to the right. Positive-rate climb was called, but the landing gear remained down and the flaps remained at 20 degrees. The first officer noticed that the captain was having "extreme" difficulty in rolling the airplane level, but eventually accomplished it through rudder and asymmetric thrust. As the right turn brought the airplane around to runway 13, the captain was able to land long, but the airplane then left the runway and impacted the airport perimeter fence. The first officer also noted that there were no warning lights or advisories in the cockpit during the event.

According to the captain, the preflight examination of the airplane was "normal," as were the pre-takeoff checks, including the ailerons and all flight control surfaces. After taking off and obtaining a positive rate of climb, the captain found that he needed a "little left control," and the airplane started a slow right turn which he could not stop. The captain then found that he needed differential thrust and rudder to keep the airplane from rolling over, and as he kept adjusting both, another runway came into view, and he completed the landing.

In a follow-up telephone interview, the captain further stated that as the airspeed increased, the airplane tended to roll more. He recalled thinking that the airplane might have had a flap misconfiguration, but there were no lights or warnings. As he reduced power, the right wing would start to come back up, and as he added differential thrust to maintain altitude, airspeed would increase and the right wing would then fall again. The captain found himself going through the same series of actions over and over again to maintain flight, and as he did so, he saw that the airplane was gradually lining up with runway 13 through the right window. As the airplane came around toward the runway, the captain felt that he only had a "one time shot," and did the best he could to get the airplane onto the runway.

The first officer and a passenger estimated that the maximum roll angle approached 90 degrees of bank.

According to air traffic control radio transmissions,

At 0948:47, the airplane was cleared for takeoff.

At 0950:51, a voice from the airplane stated "got an emergency return."

The tower controller then gave the airplane the winds, and the voice said, "say again," to which the controller stated use caution, cleared to land, runway three one is open.

There were no further transmissions from the airplane.

The airplane was equipped with a cockpit voice recorder that was auditioned at the NTSB Recorders Laboratory. According to the specialist's factual report, the recording began at 0902, with one of the crew members on the telephone discussing technical details of the flight management system. The passengers arrived at 0932.

After passenger arrival, the crew briefed the flight, including speeds of "twenty two, twenty three, and one thirty three" along with a single engine climbout speed of 165 knots.

At 0936:57, the crew began to perform checklists to start both engines, followed shortly thereafter by a taxi clearance to runway 26. During the ensuing taxi, the crew verified taxi routings while performing the taxi checklist in a challenge-response manner.

At 0944:39, as part of the checklist, the first officer stated, "speed brake, spoiler levers." After a "snapping sound," the captain responded about 12 seconds later with, "check…comin' up on the right T-R…after left T-R…check,"

At 0945:11, the captain began to brief the takeoff and departure, followed by his noting that the aileron boost was on.

At 0948:36, the airplane was cleared for a departure from runway 26 with a right turn to 315 degrees. The first officer acknowledged the takeoff clearance and the crew executed the last checklist before takeoff. As part of the checklist, the first officer called out "control lock and controls," to which the captain responded, "okay, it's off."

At 0949:45, the captain stated, "here we go," which was followed by the sound of increased engine noise. Shortly thereafter, the first officer confirmed power, engine instruments, and airspeed alive.

At 0950:07, the first officer called out "90 knots," followed 3 seconds later by two low frequency thumps about 0.6 seconds apart.

At 0950:15, "V1" was announced.

At 0950:23, the captain stated an expletive, followed 1 second later by the first officer calling "positive rate."

During the next 50 seconds, until airplane touchdown, the following was stated with an occasional overlap:

- Captain repeated expletive.

- First officer asked what was going on.

- Captain repeated expletive.

- Automated voice announced, "Bank angle."

- First officer stated, "Say again," and asked what he could do.

- Automated voice announced, "Bank angle."

- Captain repeated expletive.

- Automated voice announced, "Bank angle."

- Captain repeated expletive.

- Automated voice announced, "Bank angle."

- Captain stated, "let go, let go, let go."

- Automated voice announced, "Sink rate, pull up."

- A sound of two high frequency beeps about 0.25 seconds apart.

- Automated voice announced, "Pull up, don't sink."

- Captain stated, "Declare an emergency, declare an emergency,"

- Automated voice announced, "Don't sink, bank angle."

- The first officer made a radio call declaring an emergency and the intent to return to the airport.

- Automated voice announced, "Bank angle, bank angle."

- A sound of two high frequency beeps about 0.25 seconds apart.

- Automated voice announced, "Bank angle."

- The tower controller made an unintelligible transmission to the airplane, plus the winds.

- At this point, about 0950:58, the background noise decreased.

- Automated voice announced, "Terrain, terrain, too low, terrain…too low, terrain."

- The first officer asked the tower to say again.

- The tower controller made an unintelligible response, in part mentioning runway 31 and "caution."

- The captain exclaimed, "Emergency, call emergency."

- Automated voice announced, "Too low, terrain."

- The captain exclaimed, "Call emergency."

- Automated voice announced, "Bank angle, bank angle."

At 0951:13, there were sounds similar to airplane touchdown followed by intermittent thumps. Eight seconds after touchdown, there was an increased sound of rushing air and engine noise.

At 0951:24, and for the next 11 seconds, there were multiple sounds of rattles, snaps and clunks.

About 0951:47, there was a rapid decrease in background noise, coincident with the sound of a single chime.

At 0951:49, the crew announced the evacuation, and the captain stated, "I had no control."

Surveillance video at the airport captured the majority of the last part of the flight. It showed that the airplane descended to the ground in a left-wing-low flight attitude before it rolled to the right and landed on the grass to the right of runway 13 in a right-wing-low flight attitude. The airplane crossed a taxiway and continued through the grass until it went through an airport perimeter chain link fence and struck the far side of a shallow drainage ditch. There was no fire.

PERSONNEL INFORMATION

The captain, age 57, held an airline transport pilot certificate with airplane multi-engine and single engine land ratings. He also had a single engine sea rating, and ratings for the Cessna 500, Cessna 560XL, and Cessna 650. In addition, he held a flight instructor certificate for single and multiengine airplane and instrument airplane. The captain reported 14,950 hours of total flight time with 190 hours in make and model; 7 hours of which were in the previous 30 days.

The first officer, age 64, held an airline transport pilot certificate with airplane multi-engine and single engine land, rotorcraft-helicopter, and instrument helicopter ratings, and ratings for the Cessna 500, Cessna 560XL, and Cessna 650, among others. He also held a flight instructor certificate for multiengine airplanes. The first officer reported 19,000 hours of total flight time with 100 hours in make and model.

According to a representative of an aircraft maintenance firm, the firm was interested in putting the airplane on its operating certificate; however, at the time of the accident, there was no written contract or preliminary agreement. The firm provided the captain's resume to a representative of the owner, who in turn made the decision to contract with the captain. The captain then provided the first officer for the owner.

Confirmation of the arrangement was requested from the operator, the operator's attorney, and the captain with no replies received.

AIRPORT INFORMATION

Runway 13 was 4,000 feet long and 100 feet wide. An airport perimeter fence was located about 650 feet beyond the departure end of the runway.

AIRPLANE INFORMATION

The airplane was recently acquired by the owner, and a memorandum of delivery dated December 1, 2011, indicated the "full and satisfactory delivery and acceptance" on that date. At that time, the airframe hours were 5,608.3, landings were 4,487, and the left and right Garrett engines had accumulated 5,509.5 hours and 5,418.3 hours respectively.

An aircraft flight log indicated that after delivery, the airplane was flown once on December 18, 2011, and twice on December 19, 2011, for a combined total of 5.6 hours.

A review of maintenance records indicated that the original Cessna factory right roll spoiler actuator was installed on the airplane. There were no maintenance records found that related to the right roll spoiler actuator.

- Ailerons -

According to the flight manual,

"The ailerons are mechanically cable-controlled and hydraulically powered in normal operation. Direct cable actuation is maintained in the event of hydraulic system failure. If a control problem is encountered, hydraulic pressure to the ailerons can be shut off by a switch on the center pedestal or by a cam operated switch on the aileron power actuator, which activates at a predetermined control force."

- Spoilers -

According to the flight manual,

"Each wing incorporates four hydraulically actuated spoiler segments. The outboard segment is called the roll control spoiler and operates with the aileron. After approximately 3.5 degrees of up aileron movement the spoiler moves up. At full aileron, the spoiler travels 50 degrees. The middle two segments operate as speed brakes and are controlled by an infinite positioning lever on the pedestal.

In case any of the spoiler segments should float up, the airplane range could be reduced as much as 5 percent, so a spoiler hold-down system is provided. Turning the spoiler hold-down switch to SPOILER HOLD DOWN locks all spoiler panels down. The roll control spoilers may then be used in the roll mode by turning on the auxiliary hydraulic pump.

Floating of spoilers or speed brakes may be annunciated by illumination of the SPOILERS UP and SPEED BRAKE annunciators respectively.

An AILERON/SPOILER DISCONNECT handle is provided on the rear portion of the pedestal to release the tie between the aileron and the roll control spoiler in the event of a jam in either the aileron system or the roll control spoiler system. When disconnected, the pilot's wheel controls only the ailerons and the copilot's wheel controls only the roll control spoilers; consequently, the location of the jam will determine whether the pilot or copilot will control the airplane.

The roll spoilers (panels 1 and 8) are…mechanically controlled and hydraulically powered. The roll spoilers operate in conjunction with the ailerons and augment their roll control function.

Lateral control is provided by the combined actuation of the ailerons and the roll control spoilers (outboard segments). Full control wheel rotation results in +12.5, -12.5 degrees travel of the ailerons and 0 to 50 degrees up travel of the roll spoilers. Roll control spoiler movement starts after ailerons have traveled more than approximately 3 degrees.

A manual disconnect [red T-]handle [shielded by a plastic cover that has is hinged on the forward side, and must be lifted to reach the T-handle,] is available to the pilots (center pedestal) in the event of a system jam of either the aileron or the roll control system. When the disconnect handle has been activated, the pilot has control of the ailerons and the copilot has control of the roll control spoilers, whichever is operational. Reconnection of the ailerons and roll control spoilers is not possible in flight.

Lateral control of the airplane is normally by means of a hydraulic power cylinder through the crossover quadrant assembly between the ailerons and roll control spoilers. An AIL BOOST OFF annunciator light advises the pilot of loss of aileron power."

- Pre-Certification In-Flight Spoiler Malfunction Testing -

The following is excerpted from a Cessna flight test results paper (Report FT650-13) prepared on June 16, 1982, in regards to meeting FAR 25.671 requirements for control system (spoiler) malfunctions:

"The spoiler failure was simulated by commanding (at the actuator) the #8 [right] spoiler to the full up position and holding the spoilers down with the spoiler hold down switch. When the spoiler hold down was removed, the #8 spoiler went full deflection and the #1 spoiler was enabled as a normal roll spoiler….

The aircraft was…slowed from 350 knots through stick shaker speed (102 KCAS) with the failed #8 spoiler. Twenty degrees of flaps were extended at 180 knots and landing flaps and gear were extended at 140 knots….

A roll rate of 25 degrees/second could be produced at 115 KCAS with flaps at 20 degrees and gear extended, and 30 degrees/second with flaps fully extended and gear extended….

The last hardover was commanded on approach to landing and the approach continued through the landing. The wind given by the tower was 50 degrees adverse crosswind at 22 knots. Approach speed was 125 KCAS. Throughout the hardovers the failed spoiler was easily controlled with aileron and rudder….

The spoiler hold down function was found to be a satisfactory way of dealing with spoiler hardover….

Probable control malfunctions on the Model 650 have minor effects on control system operation and are capable of being readily counteracted by the pilot."

- Flaps -

According to the flight manual,

"The trailing edge flaps are mechanically controlled and driven by an electric power unit through ballscrew actuators and flex-drive shafts. The flaps are in three segments on each wing; however, the drive system is designed to preclude the possibility of a split flap condition. If at any time an asymmetrical flap condition occurs, the flap controller disables the system and engages the asymmetry brakes which mechanically lock the flap segments in that position. The asymmetry brakes can only be reset on the ground….A mechanical detent is provided at the 7- and 20-degree position of the flap lever."

- Emergency Procedures -

According to the flight manual, for:

"Uncontrolled Airplane Roll:"

The emergency checklist memory items are as follows (first four procedures are memory items):

1. AP/TRIM/NWS Disengage Switch – Press.

2. Control Wheel – STOP ROLL – APPLY OPPOSITE ROLL CONTROL.

IF ROLL NOT ARRESTED

3. Spoiler Hold Down Switch – ON.

IF ROLL STILL NOT ARRESTED

4. Auxiliary Hydraulic Power – OFF.

For "Jammed Roll Control System:"

1. AP/TRIM/NWS Disconnect Switch – PRESS

2. Pilot and Copilot Control Wheels – RELEASE

3. Aileron/Spoiler Disconnec

NTSB Probable Cause

The crew's failure to use proper emergency procedures during an uncommanded right roll after takeoff, which led to a forced landing with a quartering tailwind. Contributing to the accident was a faulty right roll spoiler actuator, which allowed the right roll spoiler to deploy but not close completely.